DPA d:dicate™ 2006A Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST2006A Stereo Pair
Together with the MMP-A preamp this condenser mic bridges the gap between the extreme sound quality of the d:dicate™ Microphones series and our well-known Miniature Microphones in the d:screet™ series.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
| Weight | 160 g (5.6 oz) | Color | Matte black |
|---|---|---|---|
| Dynamic Range | Typ. 114 dB | Output Impedance | 200 Ω |
| Frequency Range | 20 Hz - 20 kHz | Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase |
| Current Consumption | 2.8 mA | Microphone Diameter | 19 mm (0.75 in) |
| Temperature Range | -40°C to 45°C (-40°F to 113°F) | Polarity | +V at pin 2 for positive sound pressure |
| Directional pattern | Omnidirectional | Principle of operation | Pressure |
| Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule | Sensitivity, nominal, ±2 dB at 1 kHz | 40 mV/Pa; -28 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted | Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A)) | S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 78 dB(A) |
| Total harmonic distortion (THD) | < 1% up to 130 dB SPL peak | Max. SPL, peak before clipping | 146 dB |
| Minimum load impedance | 2 kΩ | Cable drive capability | 100 m (328 ft) |
| Output balance principle | Impedance balancing with Active Drive | Common mode rejection ratio (CMRR) | > 60 dB |
| Power supply (for full performance) | 48 V Phantom power (± 4 V) | Microphone length | 164 mm (6.5 in) |
| Maximum output voltage, RMS | 8 V | Relative humidity (RH) | Up to 90% |
| Frequency range, ±2 dB | 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz | Equivalent noise level, ITU-R BS.468-4 | Typ. 28 dB (max. 30 dB) |
| Switchable attenuator, filters etc. | 0 dB / -20 dB |
