DPA d:dicate™ 2006C Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST2006C Stereo Pair
Together with the MMP-C preamp, the ST2006C makes a small, lightweight and inconspicuous main AB stereo pair. The two 2006C comes with Clips and Windscreens all packed in a Peli™ Case.
The mics deliver precise sound and true tone. Meeting classic architecture and installation requirements, these mics can be mounted, hung or concealed to create clean, transparent recordings.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
Weight | 60g | Color | matte black |
---|---|---|---|
Dynamic Range | typ. 114dB | Output Impedance | 100Ohm |
Frequency Range | 20Hz to 20kHz | Connector | XLR-3M. pin 1 |
Current Consumption | 2.8mA | Microphone Diameter | 19mm |
Temperature Range | -40°C to 45°C | Polarity | +V at pin 2 for positive sound pressure |
Directional pattern | omnidirectional | Principle of operation | pressure |
Cartridge type | pre-polarized condenser, Twin-Diaphragm-Capsule | Equivalent noise level, A-weighted | typ. 16dB(A) re. 20uPa (max. 18dB(A)) |
Total harmonic distortion (THD) | <1% up to 130dB SPL peak | Max. SPL, peak before clipping | 139dB |
Minimum load impedance | 2kOhm | Cable drive capability | 100m |
Output balance principle | Impedance balancing with "Active Drive" | Common mode rejection ratio (CMRR) | >50dB |
Power supply (for full performance) | 48V Phantom power (+/-4V) | Microphone length | 58mm |
Maximum output voltage, RMS | 4.5V | Relative humidity (RH) | up to 90% |
Equivalent noise level, ITU-R BS.468-4 | Typ. 28dB (max. 30dB) | Frequency range, +/-2dB | 50Hz to 20kHz with typ. 3dB soft boost at 14kHz |
Sensitivity, nominal, +/-2dB at 1kHz | 40mV/Pa, -28dB re. 1V/Pa | S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL) | Typ. 78dB(A) |