GBP (£)
DPA d:dicate™ 2011A Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST2011A Stereo Pair
These mics are acclaimed for their close-miking excellence and hi-SPL handling. Optimized for onstage use, it has been used on many stages as well as recording sessions. They exhibit a previously unheard blend of clarity, richness and dynamic range. The off-axis response is linear but in a smaller frequency bandwidth. This makes stage separation and gain-to-feedback higher. The mic level is easier to control.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
| Equivalent noise level, A-weighted | Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) | Frequency range, ±2 dB, at 30 cm (11.8 in) | 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz |
|---|---|---|---|
| Switchable attenuator, filters etc. | 0 dB / -20 dB | Equivalent noise level, ITU-R BS.468-4 | Typ. 33 dB (max. 36 dB) |
| Relative humidity (RH) | Up to 90% | Maximum output voltage, RMS | > 5 V |
| Microphone length | 198 mm (7.8 in) | Power supply (for full performance) | 48 V Phantom power (± 4 V) |
| Common mode rejection ratio (CMRR) | > 60 dB | Output balance principle | Impedance balancing with Active Drive |
| Cable drive capability | 100 m (328 ft) | Minimum load impedance | 2 kΩ |
| Max. SPL, peak before clipping | 153 dB | Total harmonic distortion (THD) | < 1% up to 137 dB SPL peak |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 74 dB(A) | Weight | 164 g (5.8 oz) |
| Sensitivity, nominal, ±2 dB at 1 kHz | 10 mV/Pa; -40 dB re. 1 V/Pa | Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule |
| Principle of operation | Pressure gradient, with interference tube | Directional pattern | Cardioid |
| Polarity | +V at pin 2 for positive sound pressure | Temperature Range | -40°C to 45°C (-40°F to 113°F) |
| Microphone Diameter | 19 mm (0.75 in) | Current Consumption | 2.8 mA |
| Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase | Frequency Range | 20 Hz - 20 kHz |
| Output Impedance | 200 Ω | Dynamic Range | Typ. 117 dB |
| Color | Matte black |
