GBP (£)
Code: DPA2011A
DPA d:dicate™ 2011A Twin Diaphragm Cardioid Mic
€1,095.00
Available to Order
QtyAdd to Cart
d:dicate™ 2011A Twin Diaphragm Cardioid Mic
2011Ad:dicate™ 2011A Twin Diaphragm Cardioid Mic
PREAMP
- MMP-A standard preamp
ACCESSORIES
- Foam windscreen
- Clip
The d:dicate™ 2011 Twin Diaphragm Cardioid Mic is a directional microphone. The distinctive sound of this microphone is well balanced. It bridges the gap between the extreme sound quality of the d:dicate™ Recording Microphone Series and our well-known d:screet™ Miniature Microphone Series.
- Blends clarity, richness and dynamics
- Twin Diaphragm Capsule Technology
- Advanced Interference Tube Technology
- Superb stage separation and level control
- Modular flexibility
| Equivalent noise level, A-weighted | Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) | Frequency range, ±2 dB, at 30 cm (11.8 in) | 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz |
|---|---|---|---|
| Switchable attenuator, filters etc. | 0 dB / -20 dB | Equivalent noise level, ITU-R BS.468-4 | Typ. 33 dB (max. 36 dB) |
| Relative humidity (RH) | Up to 90% | Maximum output voltage, RMS | > 5 V |
| Microphone length | 198 mm (7.8 in) | Power supply (for full performance) | 48 V Phantom power (± 4 V) |
| Common mode rejection ratio (CMRR) | > 60 dB | Output balance principle | Impedance balancing with Active Drive |
| Cable drive capability | 100 m (328 ft) | Minimum load impedance | 2 kΩ |
| Max. SPL, peak before clipping | 153 dB | Total harmonic distortion (THD) | < 1% up to 137 dB SPL peak |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 74 dB(A) | Weight | 164 g (5.8 oz) |
| Sensitivity, nominal, ±2 dB at 1 kHz | 10 mV/Pa; -40 dB re. 1 V/Pa | Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule |
| Principle of operation | Pressure gradient, with interference tube | Directional pattern | Cardioid |
| Polarity | +V at pin 2 for positive sound pressure | Temperature Range | -40°C to 45°C (-40°F to 113°F) |
| Microphone Diameter | 19 mm (0.75 in) | Current Consumption | 2.8 mA |
| Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase | Frequency Range | 20 Hz - 20 kHz |
| Output Impedance | 200 Ω | Dynamic Range | Typ. 117 dB |
| Color | Matte black |
