DPA d:dicate™ 2011C Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST2011C Stereo Pair
Together with the MMP-C preamp, this makes a small, lightweight and inconspicuous stereo pair.
The compact design and controlled directionality of these mics make them an excellent choice for spot mics for classical recording and on-stage close mics for live sound.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
Directional pattern | Cardioid | Principle of operation | Pressure gradient, with interference tube |
---|---|---|---|
Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule | Frequency range | 20 Hz - 20 kHz |
Frequency range, ±2 dB, at 30 cm (11.8 in) | 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz | Sensitivity, nominal, ±2 dB at 1 kHz | 10 mV/Pa; -40 dB re. 1 V/Pa |
Equivalent noise level, A-weighted | Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) | Equivalent noise level, ITU-R BS.468-4 | Typ. 33 dB (max. 36 dB) |
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 74 dB(A) | Total harmonic distortion (THD) | < 1% up to 137 dB SPL peak |
Dynamic range | Typ. 117 dB | Max. SPL, peak before clipping | 146 dB |
Output impedance | 100 Ω | Minimum load impedance | 2 kΩ |
Cable drive capability | 100 m (328 ft) | Output balance principle | Impedance balancing with Active Drive |
Common mode rejection ratio (CMRR) | > 50 dB | Power supply (for full performance) | 48 V Phantom power (± 4 V) |
Current consumption | 2.8 mA | Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase |
Color | Matte black | Weight | 64 g (2.3 oz) |
Microphone diameter | 19 mm (0.75 in) | Microphone length | 92 mm (3.6 in) |
Maximum output voltage, RMS | > 4 V | Polarity | +V at pin 2 for positive sound pressure |
Temperature range | -40°C to 45°C (-40°F to 113°F) | Relative humidity (RH) | Up to 90 % |
Matching tolerance (frequency response and sensitivity) | ±0.5 dB | Phase deviation for kit | < 5° |