DPA d:dicate™ 4006C Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST4006C Stereo Pair
This kit is similar to the ST4006A Stereo Pair, using the same MMC4006 Omnidirectional Microphone Capsule to gain its amazing sound. Whenever a small, lightweight, inconspicuous microphone for top-quality recording is required, a d:dicate™ 4006C Omnidirectional Microphone is the right choice. They come as a hand-matched pair that offers the truest capture of stereo sound available.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
Weight | 63 g (2.2 oz) | Color | Matte black |
---|---|---|---|
Dynamic Range | Typ. 119 dB | Output Impedance | < 200 ohm |
Frequency Range | 10 Hz to 20 kHz | Length | 64 mm (2.5 in) |
Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin: - phase | Diameter | 16 to 19 mm (0.63 to 0.75 in) |
Current Consumption | 2.8 mA | Temperature Range | -40 °C to 45 °C (14 °F to 113 °F) |
Polarity | +V at Pin 2 for positive sound pressure | Directional pattern | Omnidirectional |
Principle of operation | Pressure | Equivalent noise level, A-weighted | Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A)) |
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 79 dB(A) | Total harmonic distortion (THD) | < 1 % up to 134 dB SPL peak |
Max. SPL, peak before clipping | 140 dB | Minimum load impedance | 2 kohm |
Cable drive capability | 100 m (328 ft) | Output balance principle | Impedance balancing with Active Drive |
Common mode rejection ratio (CMRR) | > 50 dB | Capsule diameter | 16 mm (0.63 in) |
Relative humidity (RH) | Up to 90% | Equivalent noise level, ITU-R BS.468-4 | Typ. 27 dB (max. 29 dB) |
Phase deviation for kit | < 5° | Catridge type | Pre-polarized condenser |
Frequency range, ± 2 dB | 20 Hz to 20 kHz | Sensitivity, nominal ±2 dB at 1 kHz | 40 mV/Pa; -28 dB re. 1 V/Pa |
Power supply (for full specifications) | 48 V Phantom power (± 4 V) | Output voltage, RMS | > 4 V |
Matching tolerance | ± 0,5 dB |