Designed for a broad range of long-distance broadcast, ENG and film miking applications, such as booming, dialogue, interview and table or podium use, the d:dicate™ 4018 Supercardioid Microphone offers superb flexibility through modular accessories.
This microphone is part of the flexible d:dicate™ Microphones series. It has a highly-directional supercardioid pickup pattern with a smooth and uniform off-axis frequency response.
The supercardioid shape is frequency independent, securing an identical sound color around the microphone. The usual rear lobe heard on most supercardioids is minimized on this capsule. This makes it much more isolated without sudden frequency dependent peaks and dips.
The d:dicate™ 4018A Supercardioid Microphone is designed for a broad range of music recording and broadcast / ENG / film long-distance miking applications. It can be used for booming, dialogue, interview and table or spot-recording use.
- Low noise and high sensitivity
- Highly directional for high isolation
- Most controlled supercardioid shape
- Uniform, frequency independent directionality
- Modular flexibility
Directional pattern | Supercardioid | Principle of operation | Pressure gradient |
---|---|---|---|
Cartridge type | Pre-polarized condenser | Frequency range | 20 Hz - 20 kHz |
Frequency range, ±2 dB, at 30 cm (11.8 in) | 40 Hz - 18 kHz | Sensitivity, nominal, ±2 dB at 1 kHz | 12 mV/Pa; -38.4 dB re. 1 V/Pa |
Equivalent noise level, A-weighted | Typ. 16 dB(A) re. 20 µPa (max. 19 dB(A)) | Equivalent noise level, ITU-R BS.468-4 | Typ. 23 dB (correct with the attenuator in 0 dB or -20 dB setting) |
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 78 dB(A) | Total harmonic distortion (THD) | < 1% up to 137 dB SPL peak |
Dynamic range | Typ. 121 dB | Max. SPL, peak before clipping | 156 dB |
Switchable attenuator, filters etc. | 0 dB / -20 dB | Output impedance | 200 Ω |
Minimum load impedance | 2 kΩ | Cable drive capability | 100 m (328 ft) |
Output balance principle | Impedance balancing with Active Drive | Common mode rejection ratio (CMRR) | > 60 dB |
Power supply (for full performance) | 48 V Phantom power (± 4 V) | Current consumption | 2.8 mA |
Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase | Color | Matte black |
Weight | 158 g (5.6 oz) | Microphone diameter | 19 mm (0.75 in) |
Capsule diameter | 19 mm (0.75 in) | Microphone length | 170 mm (6.7 in) |
Maximum output voltage, RMS | 8 V | Polarity | +V at pin 2 for positive sound pressure |
Temperature range | -40°C to 45°C (-40°F to 113°F) | Relative humidity (RH) | Up to 90% |
Matching tolerance (frequency response and sensitivity) | ±1 dB | Phase deviation for kit | < 10° |