Code: DPAMMP-ER
DPA Modular Active Cable, XLR, Rear, 3 m (9.8 ft)
€419.00
Available to Order
QtyAdd to Cart
For use with hanging mics or low-profile table or instrument mics, the MMP-E Modular Active Cable Preamplifier can be combined with any modular capsule in the d:dicate™ Microphones Series.
It features a high quality preamplifier split into a 12 mm housing and a 3-pin XLR connector. These components attach the capsule to a cable at a length of 3 to 30 meters. It is an ultra-transparent preamplifier with active drive for impedance balancing to reject frequency interference.
rear cable entry.
| Weight | 91 g (3.2 oz) | Color | Matte black |
|---|---|---|---|
| Dynamic Range | 131 dB | Output Impedance | 100 Ω |
| Length | 3 m (9.8 ft) | Diameter | 19 mm (0.75 in) |
| Current Consumption | 3.5 mA | Temperature Range | -40 °C to 45 °C (-40 °F to 113 °F) |
| Minimum load impedance | 2 kΩ | Cable drive capability | 100 m (324 ft) |
| Output balance principle | Impedance balancing | Common mode rejection ratio (CMRR) | > 40 dB |
| Power supply (for full performance) | 48 V Phantom power (± 4 V) | Relative humidity (RH) | Up to 90 % |
| Output voltage, RMS | 2.2 V | Output connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase |
| Low-cut frequency, -3 dB | 15 Hz | Noise with shorted input A-weighted | 0.6 µV |
| Output voltage, peak | 3.1 V | Type of electronic circuit | Active |
| THD@1VRMS, 1kHz | < 0.2 % |
