This Smart Socket kit includes a front lid that takes a single Neutrik D series connector or equivalent.
This Smart Socket kit includes a front lid that takes a single Neutrik D series connector or equivalent. Typical applications are for the provision of control data outlets on a lighting bar using 3 or 5 pin XLR or CAT5/6 Ethernet connectors. Alternatively, 3 pin XLR and SpeakON connectors can be fitted to provide audio inputs and outputs. Kits are shipped with all the necessary screws to assemble them along with full fitting instructions; to fit them you only need to drill a single 16mm hole in one wall of the tube. Then, simply press the Smart Socket into place and tighten the 2 self tapping screws; you can then install the wiring for your lighting bar.
FEATURES
- Designed for 48.3mm outside diameter aluminium scaffold tubing
- Shipped all the necessary screws and full fitting instructions
- Requires D-Type panel mount connector (available separately)
- Injection moulded in tough, resilient ABS and comprise of 3 parts, the body, lid and clamp
- Note: The Robolights SmartSocket should only be installed by a suitably qualified person. The installer must also ensure that the final assembly conforms to and is in accordance with, all regional electrical wiring regulations prevailing at any time. When using this Smart Socket, be sure to check that there is enough space inside the Smart Socket for the connector you are going to use
